| Test item 测试名称: | |
| American National Standard for Plastic Bathtub and Shower Units 塑料浴缸以及淋浴底盘美国标准 | |
| Norm refer 涉及标准: IAPMO | |
| Test info 测试内容： | |
| Clause | Test Requirement |
| 2 | General requirement 一般要求 |
| 2.1 | Material 材料 |
| 2.2 | Dimensional tolerances 尺寸 |
| 2.3 | Units for testing 测试单元 |
| 2.4 | Installation instruction 安装说明 |
| 2.5 | Care and maintenance instruction保养维护说明 |
| 2.6 | Identification 鉴别 |
| 2.7 | Grab bars 扶手 |
| 2.8 | Raised flanges and tiling beads. 轮廓 |
| 3 | Workmanship and finish 表观工艺 |
| 4 | Structural integrity of complete units (all types) |
| 4.2 | Drain fitting connection 排水部件连接 |
| 4.3 | Point impact loads 点冲击 |
| 4.4 | Loads on seat 座椅负载测试 |
| 4.5 | Loads on rim and bottom of bathtubs, and on threshold and bottom of showers |
| 4.6 | Area impact load on wall surrounds 墙面冲击 |
| 4.7 | Loads on wall surrounds 墙体负载 |
| 4.8 | Radii load test 倒角负载 |
| 4.9 | Loads on unsupported bathtub areas 不承重区域负载 |
| 5 | Physical characteristics of materials (all types) 材料的物理性状 |
| 5.1 | Colorfastness test 褪色测试 |
| 5.2 | Stain resistance test 抗污性测试 |
| 5.3 | Wear and cleanability test 磨耗与清洁能力测试 (转包美国） |
| 5.4 | Cigarette test 香烟测试 |
| 5.5 | Chemical resistance test 抗化学测试 |
| 5.6 | Ignition test 燃烧测试 |
| 5.7 | Thermal shock resistance 热冲击测试 |
| 6 | Additional material tests 附加材料测试 |
| 6.1 | Hot water resistance test method (type 1,2and3) |
| 6.2 | Laboratory test for non-integral flange-fixture seal (if applicable) |
| 6.3 | Resistance to fungl and bacteria growth (type 6) (35 working days) |
| 6.4 | Puncture resistance test (type 6) |
| Sample Size: 2 set（With installation instruction & care and maintenance instruction.） | |
| 3 pieces of specimens with 305 X 305 mm; | |
| 3 pcs of samples with size 4” X 15”; | |
| 3 pcs of 6” X 6” pieces of material | |
| (If clause 6.3 is applied, 4 pieces of 50 X 50 mm specimens shall be needed.) | |
| TAT: 22 working days | |
| (If clause 6.3 is applied, the TAT shall be 37 working days.) | |
Sample for reference 参考图片:
